Practically Classics Forum

Posted: **Thu Feb 27, 2014 1:04 pm**

I'm looking to add some wires to the loom on my MGB GT project, namely the starter switch to push button starter, the ignition coil terminal wires and a few other bits and bobs. Will this wiring do?

http://www.ebay.co.uk/itm/291008632050? ... 2234wt_946

Its 1mm (thick?) thinwall but I'm not sure whats on the new loom interms of thickness etc. If this isnt suitable can someone show me where to get some that is and with the choice of colours I want?

Thanks.

Posted: **Thu Feb 27, 2014 1:12 pm**

Sounds a bit light to me.

I'd get some proper vehicle wire from these people:

http://www.vehicle-wiring-products.eu/V ... mepage.php

I'm sure they'd be happy to discuss and advise if you give them a ring.

Posted: **Thu Feb 27, 2014 1:14 pm**

Perfect, thanks Luxobarge! Extrememly fast response too

Once the weather (and funds, I just started a new job) improve work will commence on the MG again. I aim to have it on the road by September.

Practically Classics Forum

Wiring to add to loom, is this suitable?

Wiring to add to loom, is this suitable?

Re: Wiring to add to loom, is this suitable?

Re: Wiring to add to loom, is this suitable?