I'm currently rebuilding my MGB 1800 18V engine and I've found a 'strange hole'. Does anyone know what it's for?
On the right side of the engine just below and right of the oil pressure take off and oil cooler hose there's a hole which was blanked off. I removed the closing bolt and found about an inch of dried carbon type stuff. I poked in the hole and dug out the gunk. I've put an air nozzle down the hole but it doesn't seem to go anywhere. At the moment I've left a little petrol on there in the hope it will soak it's way through.
You could use a T piece and take two capillaries from that to the gauges or are you already using a T piece for an extra warning lamp sender switch that you'll doubtless be using for a 20psi signal in a car that competes?
J "Home is where you park it", so the saying goes. That may yet come true..
Not sure where you suggest I use a 'T' piece, in the oil cooler pipe? I hadn't thought about fitting a 20psi warning lamp. I'm not that serious about rallies, I don't do Le Jog etc.
Ah! I hadn't thought of that. I've bought one of these now --> http://www.ebay.co.uk/itm/370850251415 so I can get the temperature and pressure switch from the same place.
